The lead-acid battery is charged normally and its life is extended

Labels: Lead-acid battery is charged normally and prolonged life. Lead-acid battery is charged normally and life is extended. 1. Initial charge of new lead-acid battery Capacity has a big impact. If the charge is insufficient, the charge capacity of the lead-acid battery will not be high, the service life will be short, and the number of charging times will increase; if the charge is over, the electrical performance of the lead-acid battery will be good, but it will also damage the lead-acid battery itself and shorten its use. Life, so new lead-acid batteries should be charged carefully. For ordinary lead-acid batteries, the initial charging must be carried out according to the charging specifications before use. For dry-charged lead-acid batteries, if they need to be used within the two-year storage period specified in the instruction manual, they can be put into use after adding the electrolyte of the specified density and standing for 15 minutes without charging. However, if the storage period exceeds two years, due to partial oxidation on the electrode plate, in order to increase its charge capacity, supplementary charging should be carried out before use, and then used after charging for 5-8 hours. 2. Lead-acid batteries cannot be overcharged. I have already said that lead-acid batteries should not be overcharged during the initial charging, but after normal use, they are often overcharged. Even if the charging current is not large, the electrolyte 'boils' for a long time, except for the surface of the active material. In addition to the fact that the fine particles are easy to fall off, it will also cause excessive oxidation of the grid, causing the active material to be loosely separated from the grid. In addition to overcharging for time, the current should also be charged according to the care requirements. Under normal circumstances, the lead-acid battery charging current is optimally 10% of the battery capacity, and should not exceed 30% of the battery capacity, otherwise the battery will be easily deformed and damaged. 3. Supplementary charging of lead-acid batteries This is for start-up lead-acid batteries. Some drivers often overlook the supplementary charging of lead-acid batteries in vehicles. Since lead-acid batteries are not fully charged in the car, it is easy to cause plate vulcanization; at the same time, the amount of charge and discharge in use is unbalanced. If the discharge is greater than the charge and the lead-acid battery is in a long-term depletion state, the lead-acid battery The plates will slowly vulcanize. This kind of chronic vulcanization will reduce the charge capacity of the lead-acid battery until it is weak to start, which greatly shortens the service life of the lead-acid battery. In order to restore the active material on the lead-acid battery plate in time, reduce the sulfidation of the plate, increase the charge capacity of the lead-acid battery, and extend its service life, the lead-acid battery in the vehicle should be recharged regularly. 4. The polarity of lead-acid batteries cannot be reversed when charging. Due to the different materials of the positive and negative plates of lead-acid batteries, in addition to the active material, the negative plate is also added with materials such as barium sulfate, humic acid, carbon black and rosin to prevent negative electrodes. The board shrinks and oxidizes. In addition, the number of negative plates of each single-cell lead-acid battery is always one more than the number of positive plates, and the negative plate is slightly thinner than the positive plate. When performing the initial charge or supplementary charge of the lead-acid battery, if you do not pay attention to the polarity, the lead-acid battery will be reversed, and the positive and negative electrodes will almost become coarse-grained PbSO4, resulting in insufficient charge capacity of the lead-acid battery. Normal work, even lead-acid batteries are scrapped. Therefore, you must pay attention to the polarity when charging, and do not reverse the polarity.
Anyone who has seen the latest top lead acid battery manufacturers sealed lead acid battery in operation cannot help but be impressed with how far the technology has progressed over the past few years.
Shenzhen Power Kingdom Co., Ltd. is a professional manufacturer of offering some of the best in class sealed lead acid battery solutions to global market. Click Power Kingdom to learn more.
According to the latest social survey, more than 50 percent of consumers (across all age demographics) follow a brand before purchasing a product. Therefore, Power Kingdom's content can make or break a customer's decision to conduct business with you.