Battery parameter setting management

　　Battery parameter setting management:

　　Floating charging voltage: 2.23-2.25V/single (25℃)

　　24V system: 26.76-27.0V 48V system: 53.52-54.0V

　　 Floating charge voltage temperature compensation coefficient: -3.0mV/℃ (reference temperature is 25℃)

　　Uniform charging voltage: 2.35V/cell (25℃)

　　24V system: 28.2V48V system: 56.4V

　　 Constant charge voltage temperature compensation coefficient: -5.0mV/℃ (reference temperature is 25℃)

　　 average charge Frequency: 6 months/time (180 days)-special circumstances

　　 Average filling time: 12 hours, average current limit: 0.1-0.25C10.

　　High voltage alarm: 24V system: 28.5V48V system: 57V

　　 Low voltage alarm: 24V system: 23.4V48V system: 47V

　　 Switching voltage: 24V system: 22.2V 48V system: no setting (depending on the situation)

　　 unified floating mortgage conversion Standard:

　　 1. The ratio of charge and discharge capacity to capacity is 95%/2, the discharge time is greater than 30 minutes, the discharge voltage is less than 49V, and the discharge voltage is less than 49V.

　　Floating charging standard: 1. Steady current and equalizing charging time: 180min; Steady current and equalizing charging current: ≤006C10/group daily maintenance and management

　　Monthly check battery items: single battery floating voltage, battery total pressure and load current; battery appearance; battery rod and safety valve leakage or acid mist; battery ambient temperature and environmental conditions.

　　-Required equipment: digital multimeter, clamp ammeter, thermometer.

　　Note: If conditions permit, the internal resistance of the battery can be measured with the required internal resistance meter: the internal resistance meter is checked every six months:

< /p>

　　 Tighten the connecting screws and charge for 12 hours.

　　Required equipment: wrench (or set of brass wrenches)

　　Check the battery every year:

　　 conducted a 30-40% C10 nuclear discharge test on the battery pack.

　　GB/T1497-1988 Feeder busbar, cable and connector voltage drop measurement method

　　-Required equipment: Digital multimeter, clamp meter, thermometer, dummy load, cable, etc.

　　Inspect items every three years:

　　 The battery pack has been subjected to a discharge test of 80% C10 capacity.

　　Contact: Power Kingdom